A stunning 2001 Carver 404 Power Boat. Extensive maintenance and upgrades to the propulsion and navigation systems. Well maintained throughout and a must see for those looking for a turn key vessel in this size range.
For entertaining or relaxing, the 404 Cockpit Motor Yacht features a super-sized aft deck and hardtop with arch and wing doors for weather protection. The large cockpit is great for water sport enthusiasts – and to make boarding easier, there’s an oversized transom platform. Belowdecks, the available lower helm station provides weather-proof cruising options, and the fully equipped galley is perfect for any meal preparation, with a three-burner stove, oven, upright refrigerator/freezer and stainless-steel sink.
40 ft 2 (approx.), integral to hull and deck, self-draining. Aft deck stairway – spiral, with 2 stainless steel hand rails. Cleats (2) – 12″ stainless steel, through-bolted through aluminum backing plate, inboard-mounted with stainless steel hawse pipes. Direct access to master stateroom. Hatches (3) – aft bilge access, guttered, watertight. Lights (2) – courtesy, with exterior-mounted switch. Transom door – fiberglass, stainless steel hardware, secures open and closed.
SALON – 110V outlets (2) – GFCI protected. Carpet – beige, tufted cut pile, 65 oz., crush-resistant, 100% nylon. Chair. DC distribution panel – 12V safety systems. Designer decor. Dry bar – in cabinet, built-in bottle and glass holders. Entertainment group – TV/VCR, with wiring for 2 speakers each in salon, master stateroom, and command bridge. Entrance door – tinted acrylic, curved, sliding, handle lock. Floor access hatches – engine room and amidships bilge. Fresh air fan (in lieu of optional air conditioning). Lights (6) – halogen, overhead, recessed. Miniblinds – decor-matched. Rocker light switches. Sofa – Flexsteel, chamois UltraLeather, with double incliners and chaise. Telephone connector. DINETTE – 110V outlet – GFCI protected. AC and DC distribution panels. Bench seats – chamois UltraLeather, convert to double berth. Carpet – beige, tufted cut pile, 65 oz., crush-resistant, 100% nylon. Designer decor. Full-width mirror. Light – halogen, overhead, recessed. Rocker light switches. Storage – behind mirror. Storage – beneath seat. Storage drawer – beneath seat. Table – 44″ x 32.5″.
AC/DC distribution panels with magnetic circuit breakers and integral bilge blower controls; AC voltmeter; AC ammeter. Batteries (2) – deep cycle, marine (12V). Battery charger – electronic, AC-DC converter. External connectors – CATV, telephone. Ground Fault Circuit Interrupt (GFCI) protection – all 110V outlets. Shore power connector – 30 amp. Shore power cord – 50 ft. Wiring system – tinned copper strand wire, harnessed, color-coded, labeled, meets or exceeds ABYC standards.
Volvo 7.4Gi engines (2). Dripless shaft logs. Exhaust mufflers – engines. Fuel tanks – welded, baffled 5052 aluminum. Hydraulic steering. Propellers. Propeller shafts – aquamet. Rudders – 421 manganese bronze. Cutlass bearings – synthetic rubber composite. Struts – 421 manganese bronze. Trim tabs – stainless steel, hydraulic. Top speed of boat: 28mph.
Anodes – zinc, sacrificial. Battery selector switch. Battery restraint brackets. Bilge blowers (12V). Bilge pumps (3) – 1500 gph each, automatic/manual operation. Brass valves for all underwater thru-hulls. CO detectors in salon and staterooms. Compass – illuminated. Engine alarms – temperature and oil pressure. Fire suppression system – automatic, FE241 (FM200 in European Community). Galvanic isolator/zinc saver. Horn – air/electric (12V), trumpet. Internal bonding system. Molded nonskid surfaces on all walk decks – diamond pattern. Navigation lights (COLREGS).
Solid fiberglass hull bottoms with Knytex substrates and Vinylester barrier coat. Molded fiberglass stringer system. Hand-laid, molded fiberglass components featuring composite laminate hullsides, decks, and cabintops. Structural engine mountings – reinforced stringer mountings with gusseted, angle steel plates. Fabricated aluminum floor frames with stainless steel stanchions. Cherry wood bulkheads, cabinetry, and trim throughout cabin, with high gloss finish. Tinted, tempered safety glass frameless window systems. Unitized deck and cabintop construction with integral aluminum truss reinforcement in cabintop structure.
AFT DECK – 110V outlets (2) – GFCI protected. 67 ft2 (approx.), integral to deck. Cabin stairway – integral to deck. Command bridge stairway – integral to deck. Electronics arch – custom aluminum with acrylic polyurethane surface coating and UV protection. Electronics arch access plates – corrosion-resistant polymer attached with noncorroding screws and waterproof sealant. Hand rail – 17″ stainless steel, on command bridge stairway. Hand rail – 17″ stainless steel, on cabin stairway. Hardtop over entire aft deck. Light – courtesy, recessed, with exterior-mounted switch. Transom door – fiberglass, stainless steel hardware, secures open and closed. SIDE DECKS – Bow rail – 1.0″ O.D., lineal-buffed, welded stainless steel, with additional intermediate rail amidships and forward. Bow rail stanchions – double-welded (inside and outside), stainless steel, anchored to aluminum backing plates laminated into deck. Cleats (4) – 8″ spring, stainless steel, through-bolted through aluminum backing plate. Deck toe rail. Grab rails (2) – 68″ stainless steel, over cabin windows. Rail gates (2) – port and starboard. Rub rail molding – heavy-duty, stainless steel insert. FORE DECK – Cleats (2) – 10″ stainless steel, through-bolted through aluminum backing plate. Cleat – 10″ stainless steel for anchor line, through-bolted through aluminum backing plate. Pulpit with stainless steel hawse pipe for anchor chain.
COMMAND BRIDGE – Access doors (2) – provide access to wiring in forward bridge. Beverage holder – bulkhead-mounted, fold-out. DC distribution panel – bridge 12V systems. Light – courtesy, recessed. Lounge – forward, with storage below, accommodates 4 adults. Lounge – next to helm seat, accommodates 3 adults. Self-draining walk surface. Stereo speakers (2). Windshield – venturi-style, wraparound aluminum frame. HELM – Accessory space – for installing navigation equipment. Adapter – 12V. Beverage holders (2) – recessed, integral. Grab rails (2) – 11″ stainless steel on either side of helm console. Helm seat – adjustable, high-quality marine-grade upholstery, embroidery stitching. INSTRUMENTATION – Gauge – synchronizer. Gauges (1 set per engine) – oil pressure, engine temperature, engine battery voltage, fuel level, engine hours, tachometer. Rotary switch controls.
110V outlets (2) – GFCI protected. Bedside endtable – solid surface top, storage drawer beneath. Berth – double, inner-spring mattress, offset. Carpet – beige, tufted cut pile, 65 oz., crush-resistant, 100% nylon. Cockpit door – sliding, tinted glass in aluminum frame, dual latches. Designer decor. Designer curtains – decor-matched. Entrance door – secures open and closed, stainless steel hardware. Hanging lockers (2) – 18.5″ hanging bar, automatic light. Lights (4) – halogen, overhead, reading, recessed. Lights (2) – halogen, overhead. Miniblinds – decor-matched. Portlights (2) – screened. Rocker light switches. Stereo speakers (2). Storage shelves (3). Telephone connector.
110V outlet – GFCI protected. Bedside endtable – solid surface top, storage beneath. Berth – double, offset. Carpet – beige, tufted cut pile, 65 oz., crush-resistant, 100% nylon. Designer curtains – decor-matched. Designer decor. Entrance door – secures open and closed, stainless steel hardware. Hanging locker – cedar-lined back, 27″ hanging bar, automatic light. Light – reading, 24″ fluorescent. Lights (2) – overhead. Mirrored headboard. Overhead hatch – 19″ x 19″, lockable, inside screen, over berth. Padded bolster around berth. Portlights (2) – screened. Rocker light switches. Step-up next to berth. Storage drawers (4) – in side of berth.